Accordingly, Develop does not warrant, either explicitly or implicitly, that the information contained in this Service Manual is complete and accurate. CAUTION Use of controls, adjustments or performance of procedures other than those specified in this manual may result in hazardous radiation exposure. Therefore, this Service Manual must be carefully read before doing service work both in the course of technical training and even after that, for performing maintenance and control of the product properly. If width A is greater than the specified range, move the Edge Guide in the direction of the arrow. Copy the “Update Software” folder and “Update” file to drive C. Using a soft cloth dampened with alcohol, wipe the Pre-image Transfer Upper Guide Plate clean of dirt.

Uploader: JoJomuro
Date Added: 16 September 2009
File Size: 20.76 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 79651
Price: Free* [*Free Regsitration Required]

Cut out the knockout from the Right Cover. Manual printed Version Remove one Paper Detecting Board Assy mounting screw.

Download Centre

Selecting a density level that is too dark may cause the media color of the document to be reproduced, and selecting a level that is too light may produce a very faint copy.


No Set fevelop correct port. Press the following keys in this order. NO o Secure in position. Then, slide and take off two Paper Take-up Rollers.


Disconnect one flat cable and one connector from the Master Board. Remove the two screws and the Separator Roller Assy.

YES o Perform the troubleshooting procedure according to the malfunction code. Contact problems may lead to increased resistance, overheating, and the risk of fire.

Plug in the Key Counter. Place the test chart in the Duplexing Document Feeder. Amazon Advertising Find, attract, and engage customers. Before Making Copies p. Paper separato The Synchronizing Roller Sensor PC1 is not blocked even after the ing section lapse of a given period of time after the paper has unblocked the Synmisfeed detecchronizing Roller Sensor PC1. If develpp is selected, a screen appears allowing you to change the access number.

NO o Go to step 8. Use a USB cable to connect the copier to host computer.

Click the [Browse] button. Remove two screws, unplug one connector, and remove the Manual Bypass Assy. If a single adjustment procedure does not successfully bring width A into the specified range, repeat steps 5 through 7. Bin Switching Motor malfunction C0B Page The Imaging Unit should be Contact your service replaced.


Remove the Rear Cover. Paper Feed Unit optional If the prescribed procedure or tool is not used, the product may break and a risk of injury or fire exists.

Extended Manual digital Version On Cd-r To clear the count value, press the [No] key. Don’t see what you’re looking for?

Check to see if width B on the test pattern falls within the specified range. Then, slide the Paper Separator Finger Assy in the direction of the arrow and take it off.

Not use the copy track function. Wind the cable on side A around wire pulley 1 four turns counterclockwise, starting with the slit at the bottom in the front left of the pulley.

Finishing Copies “sort” And “group” Functions Non-sort function: Swing up the Document Guide Lever.