7013 SW MODEM DRIVER

Record the results obtained in steps 1 and 2 on the appropriate form. If the results are out of tolerance, circle the entry and take correc- tive action. Table Master user available operations. For instance, when using a BIRD wattmeter for power measurements, the same set of rf bodies, wattmeter, and elements must be utilized due to the variability of the wattmeter components. Check that the equipment carries out a changeover to Tx 2 before shutoff.

Uploader: Tygokinos
Date Added: 2 January 2006
File Size: 48.93 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46272
Price: Free* [*Free Regsitration Required]

Use Mode, software to upload configuration to the replaced monitor board. As a shortcut for this step, you can just press the highlighted letter of the menu title. Readout of all the maintenance values and warning limits.

This check confirms that the shutdown occurs and that the remote control point is properly notified.

SIS MODEM DRIVER FOR WINDOWS XP

The nominal reading should be For instance, when using a BIRD wattmeter for power measurements, the same set of rf bodies, wattmeter, and elements must be utilized due to the variability of the wattmeter components. No Is there maint. The RMM software uses the maximum config- ured monitor alarm delay to determine whether a changeover alarm is followed by a shut- down. This dialog contains a list showing the name and number of the configured stations.

  LOGITECH DRAADLOOS TOETSENBORD DRIVER

Remove old unit and place the new unit on an extender board. Why do i see many drivers? A line entry modrm the localizer normal parameters is required before a normal ground check and periodically as required in chapter 4. For dual equipment, this delay includes the transfers from main to standby to shutdown.

However, you can always get on-line Help about currently unavailable commands. This check may be omit- ted when completing the line entry from the RMM.

Sign sis 56k modem sis modem Shipping Pass so you can shop more, save money sis modem live better.

The audio morem relationship between the course and clearance signals must be in phase to ensure that these signals always add to and not subtract from each other. In order to speed up the upload process, it is a good idea to close all windows that display monitor or maintenance measurements this frees up communication bandwidth.

Dictionnaire Reve benefits of using my blog. Record in Table line f. Simulate a continuous alarm, or moddem the RMM perform a station integrity check.

Calam̩o РNormarc Ils Operating Manual Huog Dan Van Hanh

Sis sw modem driver. Figure Maintenance delay window The resolution of the maintenance delay parameters is 1 second.

  DFE-530TX D2 DRIVER

Shutdown delay a Initiate a continuous monitor alarm and measure the time between initiation of the alarm condition s and localizer shutdown. Storage type Extension Medium time periodic. The dynamic maximum point should be approximately -4 volt. Main Rss Feed Sitemap.

Normarc 7013 Ils Operating Manual Huog Dan Van Hanh 91140

If any frequency or the frequency separation at two-frequency facilities moem out of tolerance, corrective action shall be taken. Then press the Update button. TX1 TX2 Activated by: For detailed information about the algorithms used in the automatic Alarm event diagnostics, refer to section 7.

The following configuration data for the RMS board are not stored in the configuration file and therefore require manual updating: The value should be near 0 DDM. Modems supported by the Smartlink driver.

External RF Signal Generator applied as signal 0713. Also used for lamp test all lamps are illuminated when this push- button is held down.