The brightness of the indicator will decrease on receipt of AIS messages. When reading this manual please pay attention to warnings marked with the warning triangle shown on the left. Please take note of the warnings in section 1 regarding the use of antennas. Please ensure your NMEA device operates at baud. The NMEA data port provides the connection to your chart plotter and consists of four wires colour coded as shown in the table below and in Figure 8. The antenna should not be co-located or operated in conjunction with any other transmitting antenna.
|Date Added:||26 October 2015|
|File Size:||7.95 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Antenna cables Alternatively, if you wish to use an existing VHF antenna, antenna splitter products are available which allow the existing antenna to be used with two radio devices, such as a VHF voice radio and the AIS RX Providing other vessels with AIS transceivers installed are within radio range of your vessel you should see their details appear on your chart plotter or PC.
Check that the connections to the chart plotter are correct.
advanSea Rx-100 Dual Channel Ais Receiver
Any attempt to tamper with or damage this product will invalidate the warranty. Class A transceivers are mandatory on all vessels over gross tonnes on international voyages and certain types of passenger vessels under the SOLAS mandate. AtoNs are transceivers mounted on buoys or other hazards to shipping which transmit details of their location wis the surrounding vessels. Please dispose of the packaging in an environmentally friendly manner.
These are important messages for safety, installation and usage of the product. The use of ScotchlokTM connectors is recommended for this purpose.
Please refer to the user manual supplied with your chart plotter for details of how to connect and configure your chart plotter for use with AIS devices.
Also included on the CD is the product manual. If you are using charting software running on a PC, please refer to the instructions provided with your chart plotting software for details of how to configure it to display AIS information.
Please refer to section 3. Class A transceivers transmit at a higher VHF signal power than class B transceivers and therefore can be received by more distant vessels, and also transmit more frequently. Please take note of the warnings in section 1 regarding the use of antennas.
Naucat – nautical magazine :: EN :: Electronics :: Plastimo AdvanSea AIS RX
Accuracy of this manual Every effort has been made to ensure the packaging for this product is recyclable. If it is not sufficient you will need an extension cable. Please refer to your chart plotter manual for more information. You may also need to enable the display of AIS targets in the chart options. Please ensure all items are present and if any of the items are not present contact your dealer.
Connect the black wire to the supply negative terminal. The NMEA data port provides the connection to your chart plotter and consists of four wires colour coded as shown in the table below and in Figure 8. In addition to the items provided with your AIS RX the following items will be required for installation: The port operates at baud. Please refer to Figure 6 for guidance. If you require longer cables to reach your power supply, please ensure the cables are capable of carrying advnasea average current of up to mA.
Similar to class A transceivers in many ways, but are normally lower cost due to the less stringent performance requirements. Do not install this equipment in a flammable atmosphere such as in an engine room or near to fuel tanks. We constantly strive to achieve the highest possible quality standards, should you encounter any problems with this product, please contact your dealer who will be pleased to offer whatever assistance you require.
This equipment is intended as an aid to navigation and is not a replacement for proper navigational aid. This product has been engineered to advanseaa you the highest level of performance and durability and we hope that it will provide many years of reliable service.
Advansea AIS RX-100
VHF antenna Installation 3. Please contact your dealer for details of suitable products. These advansex similar to class B transceivers, but are designed to be fitted to large vessels such as cargo ships and large passenger vessels.
The brightness of the indicator will decrease on receipt of AIS messages.