Boot Other Device Default: This program should be executed under the following conditions: Return the jumper cap to the Normal operation setting. The system has various power saving modes including powering down the hard disk, turning off the video, suspending to RAM, and a software power down that allows the system to be automatically resumed Page 10 DMA, timer, and interrupt controllers. Take care how you use this program.

Uploader: Tobar
Date Added: 15 February 2004
File Size: 23.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 57344
Price: Free* [*Free Regsitration Required]

Disabled If you enable this item and restart the system, any Plug and Play configuration data stored in the BIOS setup is cleared from memory. Each connector has the pin-1 side clearly marked. When an option is highlighted, you can execute the option by pressing the enter key.

EXE to install the application software. Soumd this item to enable or disable the ACPI feature. You cannot use more than eight characters or numbers.

Matsonic MSC (MSSM) Free Driver Download for Windows 98SE, 98, 95 () –

When the installation is complete, remove the floppy diskette from the diskette drive and restart your computer. Function Jumper Setting Normal operation When installing a CPU heatsink and Caution! Static Electricity In adverse conditions, static electricity can accumulate and dis- charge through the integrated circuits and silicon chips on this product. When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surface-mount resistors with the clip of the cooling fan.


Return the jumper cap to the Normal operation setting.

For some add-in cards, for example graphics adapters and network adapters, you have to install drivers and software before you can begin using the add-in card. This chapter guides you through the Setup Utility by providing clear explanations for all Setup Utility options.

Standard Cmos Setup Option 8. After the POST routines are completed, the following message appears: If the item is set to Delay 4 Sec. Matching the pin-1 corners, m7s127c the processor into the socket. If your mainboard has this jumper, change the setting to allow BIOS flashing. AGP technology provides a direct connection between the graphics sub-system and the processor so that the graphics do not have to compete for processor time with other devices on the PCI bus.

8SFxmtiu Sound Driver

Refer to your operating system handbook for instructions on in- stalling Linux drivers. The middle jack is for a stereo line-in signal.

Wake Up Events This item opens a submenu that enables you to set events that will resume the system from a power saving mode. Installation Quick Installation Table This chapter explains how to successfully siund the mainboard into a computer case and build a working system. When your system is in a power—saving mode, any incoming calls to the sm7127c automatically resume the system.

Disabled Use this item to enable LAN or modem activity to wakeup the system from a power saving mode.


You must install at least one module, and it makes no difference which slot you use to install the module. ON When this item is enabled, the system will restart the power-saving timeout counters when any activity is detected on the hard disk drive or the floppy diskette drive.

You usually answer these dialogs by typing Y for yes and N for no.

The integrated super IO controller supports two serial ports, an IR port, parallel port, and floppy disk controller functions. Before attempting to configure a hard disk drive, make sure you have the configuration information supplied by the manufacturer of your hard drive. Setting passwords have this kind of dialog box.

Matsonic Sound Card Drivers Download

This mainboard has a built-in VGA graphics system; you must leave this item at the default value. We recommend mms7127c you leave this item at the default value. Power Management Timeouts The power-saving modes can be controlled by timeouts.

When disabled, a write buffer is not used and the CPU read cycle will not be completed until the PCI bus signals that it is ready to receive the data.