Depending on the driver, it does not provide native monitor mode or injection support. It is not uncommon that you are not running the correct module version. This is due to mac returning the signal strength values in dBm, which is almost always a negative number, and aircrack-ng treats the negative reading incorrectly. But hey, that’s all part of the fun! It has the huge advantage of being included in the kernel itself. Even if fixing something does take hours

Uploader: Maurg
Date Added: 5 March 2015
File Size: 50.58 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6905
Price: Free* [*Free Regsitration Required]

Of specific interest to aircrack-ng is native monitor mode and injection support. You can download it from here. Where the mac version of the driver is stable and supports injection, that should be your first choice.

Then See this FAQ entry. Post Your Answer Discard By clicking “Post Your Answer”, ajrcrack acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

See this write-up for more detail.

macbook [Aircrack-ng]

Follow this tutorial Tutorial: So you remove all the old ones:. Haxornator 6 1 3.

You’ll then have to extract the right firmware for b43 and install that: The fix-tx-ctl-no-ack patch is NOT a replacement for the fragmentation patch, it is an additional patch that some drivers require in addition to the fragmentation patch. So with this as background, here is troubleshooting information for problems that arise when both stacks are installed on a system.


The following drivers use mac not all have been tested to work with aircrack-ng: Sometimes other modules conflict with the one you are trying to run.

Broadcom b43 bg to capture n

Then you modprobe -r via the driver it is using and reload those drivers again via modprobe. You are using the legacy driver for your device and want to switch to the mac driver. Mac introduced changes to monitor mode to support the Radiotap standard.

Device or resource busy” when setting monitor mode. Having wifi0 or eth0 typically means you are using the older legacy ieee drivers.


This page is deprecated, updated documentation can be found here. Then you’ll have to blacklist the old drivers you can just blacklist find meand either reboot for simplicity, or unload and reload the modules.

You can tell if you are running the new mac stack based on the kernel version or you likely get an error message similar to:.


If it does not match, then you are not running the patched module. You might need the injection patch and obviously apply the patch.

B43 supports the fragmentation attack, and it’s much more stable than bcm43xx. Except where otherwise noted, content on this wiki is licensed under the following license: Once you have removed it, do pccardctl insert and the driver should be loaded automatically. This is aircrqck with the rmmod and modprobe or simply modprobe -r and then modprobe commands. Basically I have a Dell Inspiron which I’ve installed The mac drivers are improving very rapidly. Updating to at least 1. aircraack

H43 wmaster0 typically indicates you are using the new mac drivers. After building and installing the new module, it is best to test that injection is working correctly. First, double check that you are in fact running the new module: Sometimes you want to try the latest mac driver without recompiling your entire kernel.