|Date Added:||20 January 2018|
|File Size:||32.20 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If it has a rollfeed plotter, use the paper cutter to cut off the bottom of the page, flush with the slot in the plotter’s platen. Rotate the page 90 degrees clockwise and reload the media in the plotter. Handle the film by the edges so as not to get fingerprints on it.
If it does not have a paper cutter, use a sharp blade or another cutting device.
HP Computer Museum
Raise the paper-loading lever. Calibrating will display on the front panel and the calibration sequence will begin. Take care to accurately align the left pinch wheel with the left edge of the media. The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen.
HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots
Remove the media from the plotter. Pen 8 will then be retrieved from the pen holder and a square will be drawn. Please try again shortly.
C Draftmaster SX Pen Plotter | eBay
When cutting and reloading the media, place the cut edge along drwftmaster left side of the platen. The pen holder will move across the media several times, sensing the corners of the square just drawn.
Load a sheet of E or D size polyester film in the plotter. The cut edge of the media draftmadter be along the left side of the plotter. The message Calibrating will display. Then, check the following and start over:.
7595C Draftmaster SX Pen Plotter
Europe, Middle East, Africa. The Virtual Agent is currently unavailable. Carefully align the line on the left pinchwheel with the left edge of the media.
Asia Pacific and Oceania. Calibrating makes the plotter’s drawing characteristics as accurate as possible. Turn the plotter off and then on again before plotting. Raise the plotter’s carriage cover. The pen holder will move across the platen.
This includes both the stripe and the white dots on either side. Make sure the pen is in good operating condition and has a tip draftmawter of 0. When reloading polyester film, place the writing surface face up; make sure the left dfaftmaster wheel is correctly aligned with the left edge of the plotting media. The plotting environment differs considerably from the calibration environment at the factory 18 to 30 degrees C, level floor.