FUTABA T6EXHP DRIVER

Might want to throw a little expo in, percent in both cyclic channels actually helps the throws to be more linear. Send a private message to JohnBuckner. Find More Posts by nellsey. Thread Tools Show Printable Version. Please enter a valid email address for yourself.

Uploader: Guzragore
Date Added: 16 October 2015
File Size: 24.75 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 36191
Price: Free* [*Free Regsitration Required]

They are very cheap on auction sites as most have gone over to 2. Use a real email address or fuutaba will not be granted access to the site. Might want to throw a little expo in, percent in both cyclic channels actually helps the throws to be more linear.

Please click one of the Quick Reply icons in the posts above to activate Quick Reply. BB code is On. Hi broke again, How can all your trim settings be zero, did you check your servo arms??

Sure the trims can be at 0 or neutral without using futaga. Please enter a valid email address for yourself. Options Quote message in reply? Remove Advertisements Sponsored Links.

John OK found it and see you are from the UK so yes that Transmitter will work with Any FM PPM receiver and either single conversion or dual conversion will work but keep in mind if the Rx is single conversion it will require a single conversion type crystal and the same applies to dual conversion. In order to verify that you are a human and not a spam bot, please enter the answer into the following t6eshp below based on the instructions contained in the graphic.

  630A VISTA DRIVER DOWNLOAD

Futaba T6EXHP Digital Proportional Radio Contolled System Helicopter Controller

Not real positive on this matter so do check locally. Thread Tools Show Printable Version. Here is the frequency band chart for most of Europe and the UK.

If the mechancial setup is correct, that is the way it should be. Beginners Beginners in RC start here for help. Send a private message to mikemhh Find More Posts by nellsey. Posting Quick Reply – Please Wait.

In order to be able to post messages on the HeliFreak forums, you must first register. You can use any Futaba 35mhz receiver, single or dual conversion, ppm or pcm. Note that passwords are case-sensitive.

Futaba T6exhp Computerized Helecopter Transmitter

Add a Poll to this Thread. My radio is set as follows-: So far it hovers hands off, so i guess im ok re, futqba. I believe the Futabas that were sold here in the north American market were sold as negative shift units but think this does t6edhp apply in the europeon market and Futabas were all positive shift.

  LH PING G15 DRIVER DOWNLOAD

Hi, As a Noob i was wondering if someone could check to see if i have my radio settings set up correctly?

Futaba T6EXHP radio- -RF reciever -S servos – RC Groups

Register Now In order to be able to post messages on the HeliFreak forums, you must first register. Quote message in reply?

Find More Posts by JohnBuckner. Last edited by JohnBuckner; at Find More Posts by mikemhh I assume your are in the uk. Send a private message to JohnBuckner. Also enable hold and set it to 0, make sure the motor is off in throttle hold, you can use this to carry it around when the futbaa is live and not hurt yourself if you slip and hit the throttle stick. Thanks for taking the time to reply.