HP PCI TACHYON TL/TS/XL2 FIBRE CHANNEL DRIVER DOWNLOAD

This addressing mode is required whenever more than 16 targets exist. Fabric mode is supported as of UX A high-speed, serial, bi-directional, topology independent, multi-protocol, highly scalable interconnection between computers, peripherals, and networks. You see a long list of claimed and connected paths. Each LCC has two 1Gb fibre channel interface.

Uploader: Grojind
Date Added: 16 September 2010
File Size: 19.20 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72612
Price: Free* [*Free Regsitration Required]

Fibre is also a general term used to cover all physical media types supported by Fibre Channel, such tahyon optical fiber, twisted pair, and coaxial cable.

FibreChannel_百度文库

According to the above WWN information and the tl/ts/dl2 configurations on the switches, we can get the matching the HBA cards to the storage front-end ports. Smallest unit of the transmission protocol between 2 N-Ports.

As a side note we are having our network team to see if traffic is moving from the host agent to the array without being blocked. The use of FC switches is mandatory.

The old device files will continue to exist until removed with the rmsf 1M command. The fields bus, target und Lun are used for the mapping of the luns, that are configured on the pcj array. VSA addressed devices are: DP autoinitialised media with some data on it.

  MODEM CREATIVE BLASTER DI5663 DRIVER DOWNLOAD

Find out Tachyon XL2 part number under HP-UX 11.11 / 11.23

Topologies A physical connection at a port consists of two separate fibers because FC is a serial protocol. The ds can be upgraded from a standalone disk system to add-on storage for the HP Virtual Array.

May 28 You can manually register the HBA. You see a long list tachhon claimed and connected paths. Or does anyone have any helpful troubleshooting hints that I may of missed? It can also be found together with latest Firmware at the HP intranet: In a Fabric environment, this node may be created as a dummy node if the HBA is scanned when it cannot see the Fabric for example, no cable attached, switch down, etc. Address of the node in FC-AL to 0.

For tll/ts/xl2 Brocade switches you can obtain the Domain ID of the switch either in the config menu of the front panel or when logged on via telnet using the switchshow command user: Should not the LTO4 tapedevice be showing too?

All nodes act as loop devices. The initialization of the link login is quite easy. For private loops, the value is 0. Please NOTE that if there are many paths between the HP-UX host and the storage, for tl/s/xl2, four paths; then all these four paths should be manually registered.

  LG C333 DRIVER DOWNLOAD

Only if this port abandons the control over the loop, the other ports will be able to arbitrate the loop again. The loop ids below are dynamically assigned. My first help post that is. Hopefully i can contribute back as well.

Basically the array can not see it. To enable the fibre channel protocol you do always need the FCMS driver as a foundation: Top Contributors Last 30 Days. Now your documentation library is available and in-sync online or off direct from the EMC Cloud.

However once networking opened things up the host registered and all the fc cards checked in. Then let’s check connectivity Status. The zoning does look solid.

Networks are non-structured and unpredictable. Only for Arbitrated Loop!